Back to Study Material School Learning

Electricity

Electricity is the flow of electric charge through a conductor. Electric charge is measured in Coulombs (C). The flow of charge constitutes an electric cur...

Electricity

Electric Circuits, Ohm's Law, and Power

Electricity is the flow of electric charge through a conductor. Electric charge is measured in Coulombs (C). The flow of charge constitutes an electric current (I), defined as the amount of charge flowing per unit time: I = Q/t, measured in Amperes (A). Conventional current flows from the positive terminal to the negative terminal of a battery (opposite to the direction of electron flow).

Electric potential difference (voltage, V) between two points is the work done to move a unit positive charge from one point to the other: V = W/Q, measured in Volts (V). A battery creates a potential difference that drives current through a circuit. Resistance (R) is the opposition offered by a conductor to the flow of current, measured in Ohms (symbol omega). Ohm's Law states that at constant temperature, the current through a conductor is directly proportional to the potential difference across it: V = IR. A device that obeys Ohm's Law is called ohmic; one that does not (like a diode) is non-ohmic.

The resistance of a conductor depends on its material, length (L), and cross-sectional area (A): R = rho x L / A, where rho (resistivity) is a property of the material. Long, thin wires have more resistance than short, thick wires. In a series circuit, total resistance R_total = R1 + R2 + R3 and the same current flows through all resistors. In a parallel circuit, 1/R_total = 1/R1 + 1/R2 + 1/R3 and the potential difference across each resistor is the same.

Electric power is the rate at which electrical energy is consumed: P = VI = I^2 R = V^2/R, measured in Watts (W). Electrical energy consumed is E = P x t = VIt, measured in Joules. The unit used commercially is kilowatt-hour (kWh), where 1 kWh = 3.6 x 10^6 J.

Worked Example: Two resistors of 4 ohm and 6 ohm are connected in parallel across a 12 V battery. Find the total resistance and the current drawn from the battery. 1/R_total = 1/4 + 1/6 = 3/12 + 2/12 = 5/12, so R_total = 12/5 = 2.4 ohm. Current I = V/R = 12/2.4 = 5 A.

CBSE Exam Tip: A very common question asks you to compare series and parallel circuits. Key points: in series, if one component fails, the circuit breaks; in parallel, other components continue to work. Household appliances are connected in parallel so each gets the full voltage (220 V in India) and can be switched independently.